Especially developed for all RC-helicopter, the AXON combines all state-of-the-srt features, without disregarding simple operation, wich is the most important point at the airfield.
Heat shrink tubing, diameter 14mm, shrinkage 2: 1, unit length 50cm
Heat shrink tubing, diameter 18mm, shrinkage 2: 1, unit length 50cm
Lipo Gens Ace 2700mAh 11.1V G-Tech XT60
You’ve just soldered two wires together, only to find thatyou’ve forgotten to fit the heat-shrink sleeve. Our new solder sleeves consign this problem to the past!
Jeti - Bag for any DS Transmitters Can be mounted on the Jeti Rucksack
Realistic harness for Max Pilot.Made like a real one, with meticulous details.
The PowerBox Pioneer is the latest development of a 14-channel power supply unit without voltage regulation, designed for HV servos.
is designed for DC/DS transmitters. This module allows to connect up to six separate controls as switches or potentiometers. The TX-MSW module is installed directly into the transmitter on the main PCB and its output connects to the internal PPM connector.
ISDT Smart Power SP3060 power supply of 60A/1800W at 220V, and delivering 24V output iC5 socket output (EC5 compatible)
Mains Power supply plug for the following Jeti radios
Jeti Duplex - REX 79SLIM ASSIST
Softpad for tray Carbon design
Precise RC transmitters benefit from all of the features that the Duplex 2,4GHz EX system can offer.
Magnetic switch is an electronic switching device designed to be used as a switch for JETI model products
The Expander SW4 is an extension for magnetic and RC switches and is designed for switching multiple devices simultaneously.
Carbon Tray for Jeti DS-12
DS - Black nuts for upper switchs
Perma-Grit -Wedge Block Coarse/Fine 140x52mm 45°
Ready to discover the joys of Rc Paragliding in size XL?As our grandmothers used to say, this is where the good soup is!
Precise RC transmitters benefit from all of the features that the Duplex 2,4GHz EX system can offer.
Opale Paramodels ESC. Best setup for advanced pilots.
100% made and designed in France
Pour 2 alimentations séparées , protection par diode Idéal pour la séparation de l'accu et du contrôleur BEC / Ou 2 accus de réceptions branchées en parallèle. Avec connectique MPX Caractéristiques : Longueur des câbles : ~15cm chacun Section des câbles : 1mm² Poids total : ~20g Tension d'alimentation : jusqu'à 16 volts Courant : 12A maximum